BiStep BS0710 ver 1.18 - how to check stepper motor

ultimateremedy

hi

I'm new to wonderful world of Stepper motors and i wanted to make a CNC machine. Please help me in following

1. I've 2 uni-polar 6-wire stepper motors(image attached) and checked its ohms (image attached). Please help where i should place which color-wire in BS0710 board. since i can't even read the volt required for the motor what i should do.

2. i need a small program to move one motor to x and other on y location. can anyone share code.

3. how i can control 3 stepper-motors as i see only two connections-port for x/y motors in BS0710

I shall be great full if someone help me.

Leon

Will that motor have enough torque for CNC?

Leon

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Amateur radio callsign: G1HSM
Suzuki SV1000S motorcycle

ultimateremedy

I'm not sure, but Initially i want to test it then later I'll change it with the better one.