I find that most smd resistors and tantalum capacitors' pads need to be widened to ease hand soldering, so that you verify the contact just by looking at it.
But I can't be customizing every eagle smd footprint and widening each one of them.....
Is there an easier way to automatically widen all the smd footprints?
Tim said...
There was another thread where I mentioned that I built my own controller using the Propeller. I just used the oven again over the weekend and it works great.
Tim did an excellent job on this toaster. We need to pop the thread up once in a while so others can learn about it. Here it is again:
Thanks Bob. I really need to get around to fixing my thermocouple. Over the weekend I turned away and my program went wild because something didn't read back right.
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Timothy D. Swieter, E.I. www.brilldea.com - Prop Blade, LED Painter, RGB LEDs, uOLED-IOC, eProto for SunSPOT, BitScope www.tdswieter.com
Comments
But I can't be customizing every eagle smd footprint and widening each one of them.....
Is there an easier way to automatically widen all the smd footprints?
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
www.fd.com.my
www.mercedes.com.my
Tim did an excellent job on this toaster. We need to pop the thread up once in a while so others can learn about it. Here it is again:
http://forums.parallax.com/showthread.php?p=767423
It's hot
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Aka: CosmicBob
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Timothy D. Swieter, E.I.
www.brilldea.com - Prop Blade, LED Painter, RGB LEDs, uOLED-IOC, eProto for SunSPOT, BitScope
www.tdswieter.com