Programming a Sabertooth motor controller
Hi everyone,
I recently started to construct a motorized skateboard with a few groupmates. We purchased a Sabertooth 2x25 motorcontroller by Dimensional Engineering to control the motion of the wheels. I am currently using pulsout commands in the basic stamp 2 to send signals to make it go forward and backward. I was wondering if anyone could help with the turning process (that is slowing one wheel down than the other to allow turning).
thanks.
-kpat
I recently started to construct a motorized skateboard with a few groupmates. We purchased a Sabertooth 2x25 motorcontroller by Dimensional Engineering to control the motion of the wheels. I am currently using pulsout commands in the basic stamp 2 to send signals to make it go forward and backward. I was wondering if anyone could help with the turning process (that is slowing one wheel down than the other to allow turning).
thanks.
-kpat
Comments