Ping Hack

Scott Estes

Why does <I Work (PING).zip> work all the time and <I work with movement (PING).zip> only works if I constantly wave my hand in front of the Ping?

Although I am a flight instructor, dare I say that I am new to Propeller and Spin?

Chris Savage

Duplicate post removed.

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Chris Savage
Parallax Engineering

Oldbitcollector (Jeff)

The working portions of the code look identical. <strange>
Try removing all the of the remarked code and compare.

OBC

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
New to the Propeller?

Getting started with a Propeller Protoboard?
Check out: Introduction to the Proboard & Propeller Cookbook 1.4
Updates to the Cookbook are now posted to: Propeller.warrantyvoid.us
Got an SD card connected? - PropDOS

Scott Estes

Do you actually run the code?

Oldbitcollector (Jeff)

Not yet.. Not near my Propeller.. *yet*

OBC

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
New to the Propeller?

Getting started with a Propeller Protoboard?
Check out: Introduction to the Proboard & Propeller Cookbook 1.4
Updates to the Cookbook are now posted to: Propeller.warrantyvoid.us
Got an SD card connected? - PropDOS

Scott Estes

I see·the problem.· vga_1280x1024_tile_driver_with_cursor.spin is exercising p0-p7 on my Propeller Demo Board.· P0 which is the I/O for Ping is being toggled at about 10hz.·· This interaction is hosing the·pin state·for my·Ping object and causes it to stall while waiting for a pin state to change.