Department of Dumb Questions - Pro Developer Board - 5 Volts

Joss

I apologize in advance for being so stooopid.

Where, on the Propeller Professional Development Board, do I access 5 volts to feed the Parallax GPS Receiver?

I slept last night and woke up clueless.

Regards

Mike Green

There's a block of sockets at X5 that provides 5V. I think it's down by the push buttons. It's in that section of the schematic.

StefanL38

Hello Joss,

my opinion it's not a stupid question it's a "beeing lazy question"

I simply did a search in the PPDB-Manual for "5v" there were a lot of hits
if you would like to have a "male" connector use the servo-headers
look up the PPDB-schematic on page 6

To keep you as lazy as you are here the pictures

best regards

Stefan

Joss

Thanks, Mike and Stefan.

I RTFM, but it didn't spell it out as clearly enough to get through my obtuse nature. I guess that is the moral equivalent of "lazy".

Regards,

Joss