Shop OBEX P1 Docs P2 Docs Learn Events
running stepper motor w/homework board — Parallax Forums

running stepper motor w/homework board

PeterRPeterR Posts: 10
edited 2008-07-30 01:09 in BASIC Stamp
I am attempting to set up a simple 90 degree foward/ reverse motion using the stepper motor "PM4222-09" and the· "Stepper Motor Controller Little Step-U" board.· Will I be able to use the "BASIC Stamp HomeWork Board" to control these items?· Are the pins on the stepper motor controller board designed to plug into the HW board?· I pulled the information for the Unipolar Stepper Motor (#27964) as examples of· programming.··Will the·sample programs run the motor referenced above ?· Does Parallax have a basic·schematic as a·starting point for·running these components?
PeterR

Comments

  • FranklinFranklin Posts: 4,747
    edited 2008-07-30 01:09
    Check out the info provided on the pages for the parts you are interested in. There is almost always datasheets and sample programs available there.

    ▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
    - Stephen
Sign In or Register to comment.