Oled 128
Praxis
Posts: 333
We are currently doing a contracted design for a customer that uses a OLED 128 x 128 Display.
The design has a separate display board with a Propeller chip plus additional EEPROM (for images etc) as well all unused I/O lines available at the interface connector, 3.3 Volt operation, on board 12 Volt supply for the display and 5Mhz crystal.
If there is any interest for this we will make this display board generally available.
Azlan
The design has a separate display board with a Propeller chip plus additional EEPROM (for images etc) as well all unused I/O lines available at the interface connector, 3.3 Volt operation, on board 12 Volt supply for the display and 5Mhz crystal.
If there is any interest for this we will make this display board generally available.
Azlan
Comments
a couple of hundred over time,depending on cost of course