HELP with : Hyperterminal

haunteddansion

I am working on a project where I need to send simple hyper terminal ASCII commands to control an led chaser unit. How would I send these commands through a BS1 or BS2

I would like the basic stamp to basically send serial out commands to this led unit. Also how would I wire it etc.

Thanks soo much for the help!

Post Edited (haunteddansion) : 3/14/2008 4:45:50 PM GMT

Franklin

You don't need a stamp to send serial, do that directly. If you need the stamp to turn things on and off that is another thing. Let us know what it is you are trying to accomplish and what hardware you are using.

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
- Stephen

haunteddansion

I do need the stamp to do this because this is a LED device is going to be in a vehicle, so I really am trying to have the stamp send hypertermial ascii commands to the led chaser board which accepts hyperterminal ascii commands via serial to make its leds run. It is possible to send·hyperterminal commands in ascii from the basic stampl serial out and how would I go about doing it?

Franklin

SEROUT in the help file of the editor would be a good place to start.

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
- Stephen