Shop OBEX P1 Docs P2 Docs Learn Events
Lost connection on propeller — Parallax Forums

Lost connection on propeller

mosquito56mosquito56 Posts: 387
edited 2008-02-22 04:32 in Propeller 1
Is it just me or has anyone else noticed alot more "Lost connection" errors with· the new proptool?

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
·······

······· "What do you mean, it doesn't have any tubes?"
······· "No such thing as a dumb question" unless it's on the internet
········

Comments

  • Phil Pilgrim (PhiPi)Phil Pilgrim (PhiPi) Posts: 23,514
    edited 2008-02-22 03:55
    When you installed the new Prop Tool, did you also reinstall the USB drivers? If so, your latency setting may have gotten restored to 16. Change it back to 1, via the Control Panel->System->Hardware->Device Manager->Ports (COM & LPT)->USB Serial Port->Port Settings->Advanced->Latency Timer.

    -Phil
  • mosquito56mosquito56 Posts: 387
    edited 2008-02-22 04:32
    I actually did nothing. I didn't even uninstall the old prop-tool. Will give it a try thanx

    Latency is 16, have changed to 1, btw: the port defaulted to 9600 baud but when I run prop to vbbasic I always use 115,200. Changed it to higher rate and latency 1. Looks good

    ▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
    ·······

    ······· "What do you mean, it doesn't have any tubes?"
    ······· "No such thing as a dumb question" unless it's on the internet


    Post Edited (mosquito56) : 2/22/2008 4:40:44 AM GMT
Sign In or Register to comment.