I am using BS2 and parallel LCD which is not from parallax

Franklin

And you have pins 0,2 and 3 hooked up and pull·down resistors like the manual says?

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
- Stephen

bogra

Thanks lot.ya,PIN 0,2,3 are hooked up.but i did not understand how to pull down resistor?where is the resistor in the circuit?
Thanks for your quick response it really helps me to proceed with the work.
regards;
Bogra

Paul Sr.

  Prop
   Pin
     o--------------------->device
           |
           \
           /
           \   <--- "Pull Down" Resistor
           /
           |
           |
           v
          GND

Franklin

Download the manual for the parallel lcd from parallax and READ it. that is your next task.

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
- Stephen

bogra

hi,Thanks to all .i got the message on screen.
Thanks again.