my servo controller version shown as" version..."
yoyokiller
Posts: 8
Hi,
I just try to run my robot in matlab and give a postion·command·to the servo controller, but the battery goes down and when I restart again found only have one channel can be controlled,(I used channal 0,1 and channel 1 can be controlled, channel 0 servo·always fast running) I also tried in Parallax standard interface software, but still the same problem, as I swap this two channel connections, restart the system again and I found I can not running all servo controller, the com port can be found, but the version mubner always shown as "version..." I have tried many times, but still can not communication with servos, and the red led and green led on together, no act push the reset. what's wrong with my controller, is that something bad inside? anybody can show me how to solve this problem, Thanks!
Jiazhong
I just try to run my robot in matlab and give a postion·command·to the servo controller, but the battery goes down and when I restart again found only have one channel can be controlled,(I used channal 0,1 and channel 1 can be controlled, channel 0 servo·always fast running) I also tried in Parallax standard interface software, but still the same problem, as I swap this two channel connections, restart the system again and I found I can not running all servo controller, the com port can be found, but the version mubner always shown as "version..." I have tried many times, but still can not communication with servos, and the red led and green led on together, no act push the reset. what's wrong with my controller, is that something bad inside? anybody can show me how to solve this problem, Thanks!
Jiazhong