Diptrace Tutorial: PCB Layout
Here's the second Diptrace tutorial, this time I go through pcb layout.

Video
On Tuesday, I'll put up Part 3: Exporting and Ordering. And next Thursday I'll put up Part 4: Tips and Tricks. As usual, let me know if you have any questions!
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Propeller Forums RSS Feed!
Gadget Gangster - Share your Electronic Projects

Video
On Tuesday, I'll put up Part 3: Exporting and Ordering. And next Thursday I'll put up Part 4: Tips and Tricks. As usual, let me know if you have any questions!
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Propeller Forums RSS Feed!
Gadget Gangster - Share your Electronic Projects
Comments
Enjoyed both of the videos so far.
I used to teach PCB layout on the Gerber PC800 machine back in the 80's. I took the same aproach as you are using, although we did not have schematic capture at the time.
Brings back memories.
Jim
I tried to watch the Guided Tour on the DipTrace, but found out that it does not have any sound.
Will you also be covering the Component Editor and part creation?
Do you have Propeller parts available? (like Propeller DIP-40, Prototype platform, screw terminals, ...) Not that I'm lazy, but...
Thanks
Al
@hover - thanks! Hopefully a few people will see how easy it is and make their own board - it's a lot of fun and you get a project that looks really nice and professional.
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Propeller Forums RSS Feed!
Gadget Gangster - Share your Electronic Projects
Thanks. I just went back and found them. Keep up the great work.
Al
OBC
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Are you Propeller Powered?
Propeller Feature Projects: PropellerPowered.com
Visit the: PROPELLERPOWERED SIG forum kindly hosted by Savage Circuits.