Don't work when tired..
Oldbitcollector (Jeff)
Posts: 8,091
I'm sure this could have been added to the "stupid list"
but I've discovered again to not work on Propeller hardware
when tired.. [noparse]:)[/noparse]
Was building a video DAC for a Propeller board and grabbed
the following resistors.. 1M,560K,270K from my parts drawer.
After rebuilding it twice, I gave up for the night..
DUH!
OBC
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
New to the Propeller?
Getting started with a Propeller Protoboard?
Check out: Introduction to the Proboard & Propeller Cookbook 1.4
Updates to the Cookbook are now posted to: Propeller.warrantyvoid.us
Got an SD card connected? - PropDOS
but I've discovered again to not work on Propeller hardware
when tired.. [noparse]:)[/noparse]
Was building a video DAC for a Propeller board and grabbed
the following resistors.. 1M,560K,270K from my parts drawer.
After rebuilding it twice, I gave up for the night..
DUH!
OBC
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
New to the Propeller?
Getting started with a Propeller Protoboard?
Check out: Introduction to the Proboard & Propeller Cookbook 1.4
Updates to the Cookbook are now posted to: Propeller.warrantyvoid.us
Got an SD card connected? - PropDOS
Comments
LOL - I'm impressed that you had a 560K... I probably would have used a 470K and 100K combination.
At least your tired ways did not lead to something irreversible, just knock off about 3 zeros with your resistor values and you should be ok.
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Beau Schwabe
IC Layout Engineer
Parallax, Inc.
(Keeping them in the packages makes this even worse... think I would have spotted that!!)
OBC
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
New to the Propeller?
Getting started with a Propeller Protoboard?
Check out: Introduction to the Proboard & Propeller Cookbook 1.4
Updates to the Cookbook are now posted to: Propeller.warrantyvoid.us
Got an SD card connected? - PropDOS
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
For me, the past is not over yet.