Shop OBEX P1 Docs P2 Docs Learn Events
boe-bot wont run, acts like no code has been uploaded — Parallax Forums

boe-bot wont run, acts like no code has been uploaded

HavoKaneHavoKane Posts: 109
edited 2005-04-19 19:48 in Robotics
boe-bot wont run, acts like no code has been uploaded

uploaded code on switch pos.1, disconnect serial cable, switch pos.2, does nothing.

are my batteries too low, do i need to recenter my servos, are my servos dead,
i can run debug stuff in the stamp editor amd read input from the IR LEDs, whats goin on?

sad.gif·

Comments

  • Jon WilliamsJon Williams Posts: 6,491
    edited 2005-04-17 18:09
    Perhaps your servos are overloading weak batteries. Make sure you servos are not plugged in backwards.

    ▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
    Jon Williams
    Applications Engineer, Parallax
    Dallas, TX· USA
  • Don MechsnerDon Mechsner Posts: 1
    edited 2005-04-19 19:48
    I just experenced this and yes it was my fault. I forgot to move the jumper for the servos and ran the batteries down.

    You may want to check the jumper is in the right place and double check the batteries.

    Don
Sign In or Register to comment.