PASM Question for register Indirect
Surac            
            
                Posts: 176            
            given the following code that should print out the COG ram on serial port in PASM
serOutCog jmprel #+1
        .counter long 1
        mov .counter, #0
.loop
        call #serCRNL     
        mov _serOutAddr_Arg0,.counter         'this will print the Address
        call #serOutAddr
        call #serSeperator
        mov _serOutLong_Arg0,.counter        'Wrong. How to copy the value IN the COG register number .counter??
        call #serOutLong
        add .counter,#1
        cmp .counter,#$1FF wc
 IF_C   jmp #.loop 
 ret
how to mov the value inside Memory location .counter to _serOutLong_Arg0 ?
_serOutLong_Arg0 is defined as long 1 in the COG

                            
Comments
Use the ALTx instructions. The documentation has the details.
This works only with cog ram, right?
Tor LUT and HUB there are other ways, right?
Addresses will warp if i go over $1FF, right?
Yes, ALTx is for cog RAM only.
For LUT you use RDLUT/WRLUT, for hub you use all the other RD/WR instructions (and WMLONG)
yes
Thank you very much
Does this mean that the P2 has a built in Warp drive and you can activate it if you access the cogram behind $1FF ?
yes
But only after this instruction:
ENGAGE