How to get servo to work on propeller?

Comments

• dirtrider444 Posts: 33

  2013-01-03 22:57 edited 2013-01-03 22:57

  Hope this helps for future people wondering the same question.....Credit to Duane Degn for helping another member on same topic
  
  
  CON _clkmode = xtal1 + pll16x _xinfreq = 5_000_000 'Note Clock Speed for your setup!! _Pin8 = 8 OBJ SERVO : "Servo32v7.spin"PUB Servo32_DEMO | temp SERVO.Start 'Start Servo handler waitcnt(clkfreq / 20 + cnt) repeat SERVO.Set(_Pin8,1500) 'Move Servo Center waitcnt(clkfreq * 2 + cnt) ' wait 2 seconds SERVO.Set(_Pin8,1000) 'Move Servo Clockwise (at least for most servos) waitcnt(clkfreq * 2 + cnt) SERVO.Set(_Pin8, 2000) 'Move Servo Counterclockwise waitcnt(clkfreq * 2 + cnt)
• StefanL38 Posts: 2,292

  2013-01-04 08:32 edited 2013-01-04 08:32

  Hi,