Prop0 Cog6 ok resnet CON:Prop0 Cog4 RESET - last status: 0 ok Hit CTL-P to exit term, CTL-Q exit nest1 CTL-R exit nest2 ... CTL-exit nest9 ÿ U-Boot SPL 2013.04-rc1-14237-g90639fe-dirty (Apr 13 2013 - 13:57:11) musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, SoftConn) musb-hdrc: MHDRC RTL version 2.0 musb-hdrc: setup fifo_mode 4 musb-hdrc: 28/31 max ep, 16384/16384 memory USB Peripheral mode controller at 47401000 using PIO, IRQ 0 musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, SoftConn) musb-hdrc: MHDRC RTL version 2.0 musb-hdrc: setup fifo_mode 4 musb-hdrc: 28/31 max ep, 16384/16384 memory USB Host mode controller at 47401800 using PIO, IRQ 0 OMAP SD/MMC: 0 mmc_send_cmd : timeout: No status update reading u-boot.img reading u-boot.img U-Boot 2013.04-rc1-14237-g90639fe-dirty (Apr 13 2013 - 13:57:11) I2C: ready DRAM: 512 MiB WARNING: Caches not enabled NAND: No NAND device found!!! 0 MiB MMC: OMAP SD/MMC: 0, OMAP SD/MMC: 1 *** Warning - readenv() failed, using default environment musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, SoftConn) musb-hdrc: MHDRC RTL version 2.0 musb-hdrc: setup fifo_mode 4 musb-hdrc: 28/31 max ep, 16384/16384 memory USB Peripheral mode controller at 47401000 using PIO, IRQ 0 musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, SoftConn) musb-hdrc: MHDRC RTL version 2.0 musb-hdrc: setup fifo_mode 4 musb-hdrc: 28/31 max ep, 16384/16384 memory USB Host mode controller at 47401800 using PIO, IRQ 0 Net: not set. Validating first E-fuse MAC cpsw, usb_ether Hit any key to stop autoboot: 0 gpio: pin 53 (gpio 53) value is 1 mmc_send_cmd : timeout: No status update Card did not respond to voltage select! mmc0(part 0) is current device mmc_send_cmd : timeout: No status update Card did not respond to voltage select! No micro SD card found, setting mmcdev to 1 mmc1(part 0) is current device mmc_send_cmd : timeout: No status update gpio: pin 54 (gpio 54) value is 1 SD/MMC found on device 1 reading uEnv.txt 14 bytes read in 3 ms (3.9 KiB/s) Loaded environment from uEnv.txt Importing environment from mmc ... gpio: pin 55 (gpio 55) value is 1 4215264 bytes read in 762 ms (5.3 MiB/s) gpio: pin 56 (gpio 56) value is 1 22780 bytes read in 37 ms (600.6 KiB/s) Booting from mmc ... ## Booting kernel from Legacy Image at 80007fc0 ... Image Name: Angstrom/3.8.6/beaglebone Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 4215200 Bytes = 4 MiB Load Address: 80008000 Entry Point: 80008000 Verifying Checksum ... OK ## Flattened Device Tree blob at 80f80000 Booting using the fdt blob at 0x80f80000 XIP Kernel Image ... OK OK Using Device Tree in place at 80f80000, end 80f888fb Starting kernel ... Uncompressing Linux... done, booting the kernel. [ 0.106029] pinctrl-single 44e10800.pinmux: prop pinctrl-0 index 0 invalid phandle [ 0.222860] omap2_mbox_probe: platform not supported [ 0.492196] tps65217-bl tps65217-bl: no platform data provided [ 0.575069] bone-capemgr bone_capemgr.8: slot #0: No cape found [ 0.612176] bone-capemgr bone_capemgr.8: slot #1: No cape found [ 0.649284] bone-capemgr bone_capemgr.8: slot #2: No cape found [ 0.686394] bone-capemgr bone_capemgr.8: slot #3: No cape found [ 0.770921] pinctrl-single 44e10800.pinmux: pin 44e1080c already requested by mmc.4; cannot claim for gpio-leds.7 [ 0.781748] pinctrl-single 44e10800.pinmux: pin-3 (gpio-leds.7) status -22 [ 0.788961] pinctrl-single 44e10800.pinmux: could not request pin 3 on device pinctrl-single [ 1.119961] tilcdc 4830e000.fb: timeout waiting for framedone [ 6.303147] libphy: PHY 4a101000.mdio:01 not found [ 6.308225] net eth0: phy 4a101000.mdio:01 not found on slave 1 systemd-fsck[83]: Angstrom: clean, 64795/112672 files, 386998/449820 blocks [ 7.057631] tilcdc 4830e000.fb: timeout waiting for framedone .---O---. | | .-. o o | | |-----.-----.-----.| | .----..-----.-----. | | | __ | ---'| '--.| .-'| | | | | | | | |--- || --'| | | ' | | | | '---'---'--'--'--. |-----''----''--' '-----'-'-'-' -' | '---' The Angstrom Distribution beaglebone ttyO0 Angstrom v2012.12 - Kernel 3.8.6 beaglebone login: [ 11.600641] hid-generic 0003:1C4F:0016.0002: usb_submit_urb(ctrl) failed: -1 .---O---. | | .-. o o | | |-----.-----.-----.| | .----..-----.-----. | | | __ | ---'| '--.| .-'| | | | | | | | |--- || --'| | | ' | | | | '---'---'--'--'--. |-----''----''--' '-----'-'-'-' -' | '---' The Angstrom Distribution beaglebone ttyO0 Angstrom v2012.12 - Kernel 3.8.6 eaglebone login: root Last login: Sat Jan 1 00:00:17 UTC 2000 on ttyO0 root@beaglebone:~# ls Desktop root@beaglebone:~# ls /etc ConsoleKit init.d rc1.d ImageMagick inputrc rc2.d UPower iproute2 rc3.d X11 issue rc4.d angstrom-build-info issue.net rc5.d angstrom-version ld.so.cache rc6.d avahi ld.so.conf rcS.d bash_completion.d libnl resolv.conf binfmt.d localtime rpc bluetooth login.defs rsyncd.conf busybox.links lvm securetty ca-certificates machine-id security ca-certificates.conf mailcap.order services cron.d man.config shadow cron.daily mime.types shells cron.deny mke2fs.conf skel cron.hourly modprobe.d sound cron.monthly modules ssh cron.weekly modules-load.d ssl crontab modules.conf sysconfig dbus-1 motd sysctl.conf default mpd.conf sysctl.d depmod.d mtab syslog-startup.conf dropbear network syslog-startup.conf.busybox environment nsswitch.conf systemd filesystems obex-data-server terminfo fonts ofono timestamp fstab opkg timezone gconf os-release tmpfiles.d gdm pam.d ts.conf gimp pango udev gnome-settings-daemon passwd udhcpc.d group passwd- udhcpd.conf group- pm update-fonts-common.d gshadow pointercal.xinput version gtk-2.0 polkit-1 wpa_supplicant.conf gtk-3.0 profile xdg host.conf profile.d xinetd.conf hostname protocols xinetd.d hosts rc0.d root@beaglebone:~# cat /proc/cpuinfo processor : 0 model name : ARMv7 Processor rev 2 (v7l) BogoMIPS : 990.68 Features : swp half thumb fastmult vfp edsp thumbee neon vfpv3 tls CPU implementer : 0x41 CPU architecture: 7 CPU variant : 0x3 CPU part : 0xc08 CPU revision : 2 Hardware : Generic AM33XX (Flattened Device Tree) Revision : 0000 Serial : 0000000000000000 root@beaglebone:~#