Back to WORDS for a Tiny Forth Editor after being downed by dose of the flue. 

Those who wish to use Tiny Forth Editor on RamBlade will have to make some modifications to SAL's Proforth.spin

In addition to changing the clock, two minor changes to the PASM code are required. The reason being that, 
once a Spin file is loaded to eeprom pins 31 and 30 are no longer available on the Ramblade board. Only pins 23 and 22 are available for I/O. 

On reboot Propforth defaults back to the standard I/O pins 30 and 31, locking out the RamBlade I/O. These pins are hard coded in the PASM routine onbootPFA There maybe other ways without making changes to ProForth.spin REV 4.0 but I want to run the Editor on minimal Propforth.

If anyone can suggest a work around, It would be appreciated.  

I decided to continue with Ramblade and to support for VT100 because there are still a number of good xmem boards out there including the new C3 and I also happen to like the old Green on Black VT100 Display. 

Ron