Results 1 to 2 of 2

Thread: BS2/NX-1000 Protoboard

  1. #1

    Default BS2/NX-1000 Protoboard

    I've been prototyping a project using the NX-1000 protoboard from Parallax.
    I'm to the point of moving everything over to a semi-permanent fixture. I'd
    prefer not to solder yet, so I was planning on using a standard Protoboard
    from Radio Shack until everything is completly finalized. Can someone tell
    me where I can get a schematic/component list on how to provide power to the
    BS2 using a powersupply (w/barrel plug) like the one used on the NX-1000?

    Thanks again,
    Matt
    Last edited by ForumTools; 10-01-2010 at 06:38 PM. Reason: Forum Migration

  2. #2

    Default

    Can someone tell me where I can
    > get a schematic/component list on how to provide power to the BS2 using a
    > powersupply (w/barrel plug) like the one used on the NX-1000?

    The BASIC Stamp Manual would be a good place. It is a free download:

    http://www.hvwtech.com/downloads.htm

    ...or from the Parallax website.


    Mark Hillier, VE6HVW
    President, HVW Technologies Inc.
    Canadian Distributors of Parallax Products and other Neat Stuff
    Tel: (403)-730-8603 Fax: (403)-730-8903
    See our NEW FPGA Experimenter Board
    http://www.hvwtech.com/intro-fpga.htm
    Last edited by ForumTools; 10-01-2010 at 06:38 PM. Reason: Forum Migration

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts