PASD jumps here and there...

[nicolad76]

Hi...it is only me or PASD (great application!!!) may not jump to the right instruction when executing call #routine ?

What happens is:
example

1···· mov OUTA, m_DS
2···· call #writebyte
··· <more code here>
30···· move OUTA, m_HC
31···call #writebyte2

writebyte
······ <some code here>
writebyte_ret ret

writebyte2
······ <some code here>
writebyte2_ret ret

I have seen the by pressing F8 (not F7 ) the sequence traced by PASD will be 1-2-30-31-writebyte2

Is it possible something is wrong in my code (which is not exactly the one posted here)?

Thx!

P.S. .. is this the right place to post this question???

[jazzed]

I have used PASD extensively and have not seen such an issue.

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
jazzed·... about·living in·http://en.wikipedia.org/wiki/Silicon_Valley

Traffic is slow at times, but Parallax orders·always get here fast 8)

[nicolad76]

could it be because I use it with Windoes Vista?