Scratch built EDDIE

Thread Starter: Danielamanda1

I built this EDDIE totally from scratch. I used a old Dell PC mother board, i scratched built the controller card using a 40 pin propeller chip. i

Today, 03:00 AM by erco

Where is “ load_cog_driver_xmm”

Thread Starter: Mark Mara

I am looking at the cog_c_toggle demo as an example of how to start a cog when using XMMC. The demo code has a #if defined to switch between cognew and

Today, 02:56 AM by jazzed

Chinese supercomputer named as world's fastest

Thread Starter: Ron Czapala

http://news.yahoo.com/chinese-superc...005600823.html

Today, 02:56 AM by erco

C3+0.9.28+pthreads

Thread Starter: Rsadeika

I was just testing out my C3 board for a possible new project using pthreads, and I noticed that the example program in the SimpleIDE folder, pthreads_toggle,

Today, 02:53 AM by jazzed