Seeking Stepper sources
Archiver
Posts: 46,084
Try www.meci.com. They are located in Dayton, Ohio where they have a
warehouse open to the public. Neat place, and just full of electronic junk.
estickney
>From: "Aunt Bea" <r_fl_z@h...>
>Reply-To: basicstamps@egroups.com
>To: basicstamps@egroups.com
>Subject: [noparse][[/noparse]basicstamps] Seeking Stepper sources
>Date: Sat, 11 Mar 2000 20:48:19 GMT
>
>I am in need of Stepper motor sources, preferably reasonably priced, for
>motors in the 125-300 in-oz torque range. Thanks in advance.
>______________________________________________________
>
>
>
>eGroups.com home: http://www.egroups.com/group/basicstamps
>http://www.egroups.com - Simplifying group communications
>
>
>
>
______________________________________________________
warehouse open to the public. Neat place, and just full of electronic junk.
estickney
>From: "Aunt Bea" <r_fl_z@h...>
>Reply-To: basicstamps@egroups.com
>To: basicstamps@egroups.com
>Subject: [noparse][[/noparse]basicstamps] Seeking Stepper sources
>Date: Sat, 11 Mar 2000 20:48:19 GMT
>
>I am in need of Stepper motor sources, preferably reasonably priced, for
>motors in the 125-300 in-oz torque range. Thanks in advance.
>______________________________________________________
>
>
>
>eGroups.com home: http://www.egroups.com/group/basicstamps
>http://www.egroups.com - Simplifying group communications
>
>
>
>
______________________________________________________
Comments
be worth sending Dan (The proprietor of Camtronics) an e-mail and tell him
what you need. Dan is a great guy to deal with and not only has done a
tremendous amount to enable the home shop machinist to implement CNC setups,
but also is quite active in the area of robotics.
I have no involvement with Camtronics other than being a very satisfied
customer. I have purchased numerous steppers from him and they are always
just what he says they are. Dan was having a closeout on some NEMA 23
steppers in the 40 - 75 or so in/oz range. I picked up 5 brand new units
that seem to be in the 60 - 75 in/oz range for $5.00 each.
If you end up e-mailing him let him know that Tim in Denver sent you.
Tim
[noparse][[/noparse]Denver, CO]
timg@k... <mailto:timg@k...>
http://www.ktmarketing.com
>
Original Message
> From: Aunt Bea [noparse]/noparse]mailto:[url=http://forums.parallaxinc.com/group/basicstamps/post?postID=dYTzf_QWcvUIuqQ1zLZe73YABgOOhClNFZzJxUvHaXcBxNaAczd4Px90NCDECGvoYkL0Tw0odO3a]r_fl_z@h...[/url
> Sent: Saturday, March 11, 2000 1:48 PM
> To: basicstamps@egroups.com
> Subject: [noparse][[/noparse]basicstamps] Seeking Stepper sources
>
>
> I am in need of Stepper motor sources, preferably reasonably priced, for
> motors in the 125-300 in-oz torque range. Thanks in advance.
motors in the 125-300 in-oz torque range. Thanks in advance.
______________________________________________________