Multicore Burger - ESP32 + P2 + RP Pico
Tubular
Posts: 4,622
in Propeller 2
I think this demands to be called "Multicore Burger" -
- ESP32 S2 on the bottom (black board)
- 8 x P2 cores in the middle (blue board)
- 2 x Rasperberry Pi Pico cores on the top (green board).
Special MicroPython sauce all round.
This is one of those rare days where the Pinout Gods must be smiling, P0, P1, P14, P15, P16, P17 all directly align between the P2 and GP0/1/14~17 on the Pico. Furthermore the GND tie aligns but is one row over, and VBUS(5v) has a convenient mounting hole beside it to tie down to the P2 board 5v in.
It would still be possible to connect a couple of click boards on the top, subject to what port B pins are used for connecting to the ESP32 S2 (these are as yet unassigned)
Comments
It's looking nice. What Propeller board you're using as the Pi Pico does fit perfectly?
Kaio its one of my P2DIP40 variants sitting in the middle.
All these boards, and even Adafruit feather, and lolins and others, all seem to have converged around ~wide DIP40.