Shop OBEX P1 Docs P2 Docs Learn Events
MikroE Clicks; are there additional Click boards for which you'd like Spin2 support? — Parallax Forums

MikroE Clicks; are there additional Click boards for which you'd like Spin2 support?

Ken GraceyKen Gracey Posts: 7,386
in Propeller 2
Hello,

You're eating these Click boards like holiday crackers, cheese and salami.

These are the ones we stock: https://www.parallax.com/product-category/propeller-2/click-boards/

This is the whole selection from MikroE: https://www.mikroe.com/click

I'm happy to stock more of them. Are there additional Click boards you'd like to consume? You know the drill: if we stock them, we'll produce code for them.

Thanks,

Ken Gracey

Comments

  • RaymanRayman Posts: 13,860
    There is an amazing amount of different Click boards...

    I was looking for a 9DOF IMU, but there's so many options!
    Think I saw a 13DOF sensor, not even sure what that is...
  • RaymanRayman Posts: 13,860
    I went looking for a single chip 9DOF Click, but didn't see one...

    Can you make your own? I'd maybe make a lsm9ds1 based Click board.

    Or, there's also a Bosch 9DOF chip that appears much easier to use as it does the IMU calculations for you...
  • Ken GraceyKen Gracey Posts: 7,386
    Rayman wrote: »
    I went looking for a single chip 9DOF Click, but didn't see one...

    Can you make your own? I'd maybe make a lsm9ds1 based Click board.

    Or, there's also a Bosch 9DOF chip that appears much easier to use as it does the IMU calculations for you...

    You can make your own. We can't though, as the volume is just too low for our NRE and setup.

    Ken Gracey
  • VonSzarvasVonSzarvas Posts: 3,278
    edited 2021-01-04 08:22
    @Rayman

    Parallax has a module in stock with that LSM9DS1 9DOF :

    https://www.parallax.com/product/lsm9ds1-9-axis-imu-module/


    You can find code objects and design files at the downloads tab (under the product on that same link).
    C code libraries and BlocklyProp blocks example included. Hopefully P2+Flexprop will allow those P1 C code libraries to be used for P2.
  • RsadeikaRsadeika Posts: 3,824
    Since I ordered the Propeller 2 Mini Starter Bundle, and I am waiting for delivery, I think what would be a necessary board is the microSD click. I think that should be a good fit, now that the P2 has 512KB, to handle the driver code.

    Ray
  • RaymanRayman Posts: 13,860
    I'd be interested in a TCP/IP one...

    This one looks good:
    https://www.mikroe.com/eth-wiz-click
  • RaymanRayman Posts: 13,860
    This one is interesting...
    https://www.mikroe.com/ribus-click

    Let's you connect to the https://riverdi.com/ series of EVE powered displays...
Sign In or Register to comment.