Propeller 2 Evaluation PCBs arrived - headed to the SMT line!
Ken Gracey
Posts: 7,386
After a week's delay or more, the Propeller 2 Evaluation Board PCBs finally arrived. We've been out of stock for a few weeks and are starting another build of 200 units today.
Ken Gracey
Ken Gracey
Comments
I see the changes to the 5V headers in some places marked...
Is there a schematic available for this board yet?
EDIT: It's now on one of the DIP switches. So you easily can change back and forth even.
Did they send the right pile ?
Yes and yes. When they send extra PCBs for our evaluation, they mark them with an X instead of provide them for free.
Ken Gracey
(And I'm not talking Ale, for our UK friends!!)
Spot on!
Dip-switch control of the USB DTR signal
and
Diode protected RESn at the programming edge header, labelled with the inverse RES text. So no worries if 5V should get to that pin by accident
Perfect, good job Parallax! Missed the dip-switch change! So BOD was cannibalized?
Would still like to see the schematic.
Sure thing on the schematics- They will be published with the product, if not sooner if time allows.
Fantastic news. You might be the first to get one!
42 Eval boards left.