I admit I haven't been following the P2 development.
I have been playing with the P2 Eval board, and the one line description of each of the smart pin modes is really not very helpful.
Is there a more detailed document or post about each of the modes ?
I am trying to measure a low frequency (1KHz), but there is some jitter at the edges for about 500nSec.
The problem is that the counters on the P1 include this jitter in the count.
I need a way to ignore the signal for about 1uSec after each edge is detected.
Is there any way to do this on the P2 with the smart pins ?
Also from what I have read you need to use two smart pins to make a counter (one to count the system counter, and one to count the cycles). Is this true ?
What I would like to get is a count of the system clock cycles for 1000 cycles of the input signal. Is there a smart pin mode for that ?
Sorry for so many questions, but I'm really excited about using the P2.