Way to restore Propeller Activity Board WX to factory settings?

CrumblyIgloo · 2019-08-10 21:18

Hi,
I have a Parallaxy telepresence robot that I use for LetsRobot. I modified the Propeller's code using BlocklyProp in an attempt to speed up the servos, and they are currently not controllable from LetsRobot.
I tried resetting the firmware and calibrating, to no avail. I'm shooting for the goal of getting the robot back online at this point.
Sincerely, CrumblyIgloo

Keith Young · 2019-08-16 19:48

I might be missing something here but I think it's just an EEPROM there so you can just put in whatever program you want.

Rayman · 2019-08-24 18:25

I just used bstl v7 to upload the eeprom of a new WX board. It's blank...

Rayman · 2019-08-24 18:29

If you really want to reset the eeprom to blank, you can load the attached wx.eeprom file to the propeller using bstl (also attached).

Way to restore Propeller Activity Board WX to factory settings?

Comments