DEBUG on P2

JimFouch2

Not sure if I'm doing something wrong, but can't seem to get the DEBUG functions to work on Prop Tool 2.4.1

When I try to run this sample program...

'#ifndef __P2__
'#error this demo is for P2 only
'#endif

'
' blink in Spin
'
con
  _clkfreq = 160_000_000
  pin = 56
  delay = _clkfreq / 4

pub demo() | when
  when := getct() + delay
  repeat
    pintoggle(pin)
    ' if debug is enabled, print the next cycle
    debug(udec_long(when))
    waitct(when)
    when += delay

When I press Control+F10 to load & Run in Ram I get a message box stating there is no Propeller 1 is found.

It does find the P2 and programs it but the code seems to stop where the debug statement is.

Not sure if I'm misunderstanding how debuging works on the P2.

Wuerfel_21

Debugging isn't in PropTool yet, use PNut for that. Also: CTRL+F10 is "load top file" in PropTool, so debug will get a different hotkey.