Beginner - Jumper Settings

I have the 3.0 version of the BASIC stamp Boe-Bot. In my manual, before connecting the servos, it says I need to change the jumper settings to Vin instead of Vdd. What is the best way to do this? I have tried needle nose pliers but they are still too wide to reach the base of the "jumper" or whatever you call that black piece of plastic. Any help is appreciated.


  • PublisonPublison Posts: 10,728
    edited 2018-09-11 - 12:53:59
    Welcome to the forums.

    Try tweezers if you have them. Also, you can just grab the top of the jumper to pull it out.
    Infernal Machine
  • I used to put my pinky fingernail in from the breadboard side and wedged the thing up.
    that was before I got a pair of pliers
    Cows say “moo”, right? Well Greek cows say “μ”
Sign In or Register to comment.