PDA

View Full Version : PDB question



Wireguy
04-07-2007, 03:53 PM
Just started on the StampWorks with the PDB.· What a great board!· I am just concerned that when I first set the board up as shown and loaded the start up program, turned the board on, the power led lights, had good communication with the stamp.· But should the blue led (1K) on the pulse generator be lit?· It is not mentioned ·in the manuel for initial start up.· Thanks· for your time.

Chris Savage
04-08-2007, 04:58 AM
Wireguy,

The Pulse Generator should always have one LED lt…By default on power up the 1 Hz LED is lit. Since there is no way to turn the pulses off one of the four will always be lit. Take care.

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Chris Savage
Parallax Tech Support

Wireguy
04-08-2007, 06:42 AM
OK Chris, thanks. I wan'ted to make sure I wasn't starting with a defective board. I gotta say, if everybody here could see this PDB, they would buy one, before they·purchased anything else!http://forums.parallax.com/images/smilies/yeah.gif

Post Edited (Wireguy) : 4/7/2007 10:48:32 PM GMT

Chris Savage
04-08-2007, 07:44 AM
I myself prototype everything I can on it…Enjoy!

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Chris Savage
Parallax Tech Support