PDA

View Full Version : GET command for BS2p



basicstampede
01-22-2007, 09:32 AM
The Stamp manual version 2.2 says for GET that highest value for Location is 131.
But shouldn't that be 135? Is this a typo. error?

Zoot
01-22-2007, 09:42 AM
On the BS2p SPRAM location 135 is the highest register (where polling bits are held). 0-126 are general purpose (use 'em as you need) registers; 127-135 are special purpose registers. Under GET in the Stamp manual is a table with the SPRAM register numbers and purposes.

My copy of the Stamp manual doesn't mention anything about 131 being the limit?

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
When the going gets weird, the weird turn pro. -- HST

basicstampede
01-22-2007, 07:24 PM
Pg. 203 of BS Manual ver 2.2, at top of page, under 1st bullet, it says "0-131 for BS2p..."

Chris Savage
01-23-2007, 01:46 AM
Hello,

That is a typo and will be corrected in future version of the BSM. For now please refer to the chart below that and it will explain what each special location does. Take care.

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Chris Savage
Parallax Tech Support