PDA

View Full Version : H48C tri-axis question



woody
01-14-2007, 08:04 AM
Hi, I have an H48C that I've breadboarded onto a homework board and am having problems. When I first fired it up with the sample
code only 2 axis were showing any change. Now all I get is a -4 G reading on all 3 axis. Any suggestions. I don't believe it got zapped with static but unless I'm overlooking something obvious that is the only solution I can think of.

Any help will be appreciated.

Wayne Hilliard

Franklin
01-14-2007, 09:09 AM
Could you show us your hookup and code?

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
- Stephen

woody
01-14-2007, 09:41 AM
The code is the sample code downloaded from the PArallax site. As far as the hookup goes do you want a description or something else. It's a Parallax homework board with a breadboard area. I can describe the pin pin connections. Port 14 to pin 1, port 15 to pin 2, pin 3 ground, pin 6 +5 volts, port 13 to pin 5, pin4 No connection
Hookup wire jumpers used for connections. It's so straight forward that I just don't know. The reference voltage does read properly with the example code.

Wayne

Henrymou
01-16-2007, 02:27 PM
sweetness, I have no idea what u guys r talkin bout, I am a noobie

dandreae
01-17-2007, 12:33 AM
I would suggest re-wiring it on the HomeWork board and double check your connections.· If it still doesn't work you'll need contact tech support at support@parallax.com (mailto:support@parallax.com).

Dave

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Dave Andreae

Parallax Tech Support·