trying to control power to turn it on and off with the stamp module

[CC]

I am trying to control power to turn it on and off with the stamp module. But i need to figure out how to hook up 120 volts to my stamp module board and what circuits I should use.
Anybody give me some ideas of where to start.

Also I was looking for wireless newworking such as 802.11a,b,c,g does not matter the band. I just want a product that I can optain an ipaddress. Any ideas here?

Thanks

Chris

Post Edited By Moderator (Chris Savage (Parallax)) : 11/21/2006 4:23:09 PM GMT

[jhoyoza]

EBAY: 4-CH TTL Driv Relay PCB for Xmas decor, Basic Stamp PIC

This is a relay board that is very simple to use with the basic stamp.

http://cgi.ebay.com/4-CH-TTL-Driv-Relay-PCB-for-Xmas-decor-Basic-Stamp-PIC_W0QQitemZ180051069724QQihZ008QQcategoryZ78205Q QssPageNameZWDVWQQrdZ1QQcmdZViewItem

As the ad says perfect for, “driving heavy inductive loads such as AC motors, magnetic lock etc.” Relays contact spec - 250V, 10Amp (Not bad for around $10) TTL logic control input is perfect for the basic stamp and very easy to use.

[Chris Savage]

Hello,

·· Please see the following recent thread which also covered this subject.· Take care.

http://forums.parallax.com/showthread.php?p=616250

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Chris Savage
Parallax Tech Support