PDA

View Full Version : servo speed



ltmhall
11-14-2006, 02:48 AM
Is there any way to increase the speed of two servo motors connected to a
Basic Stamp II? Or is the

PULSOUT 1, 850
PULSOUT2, 650

fastest they will turn.

allanlane5
11-14-2006, 02:59 AM
PULSOUT 1, 1000 and PULSOUT 2, 500 would be the fastest.

Super Squirrel
11-21-2006, 12:27 AM
ya allanlane5 is right

PULSOUT 1, 1000
PULSOUT 2, 500

would be the fastest

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
The squirrels are after my nuts!!

CCraig
11-21-2006, 09:19 PM
That's the theory anyway. Test them. In real life, my servos gain no speed beyond the lower figures.



HTH, Chris

Randy Evans
11-21-2006, 11:01 PM
Running the servos at 6v instead of 5V will give you a little more speed.

Randy

Chris Savage
11-22-2006, 01:36 AM
Note that this is not a limitation of the BASIC Stamp but of the given servo. Another thing you could do but which would involve mechanical additions would be to gear the output shaft. You could put a large gear on the output shaft (spline) and drive a smaller gear connected to a wheel. Also, simply creating a larger wheel will increase speed.

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Chris Savage
Parallax Tech Support