View Full Version : Basic stamp ! to eeprom?

11-09-2006, 07:11 AM
I'm new at this, I have a question on how to interface an eeprom to a basics stamp 1. I need segestions about how to access data to and from a 4k eeprom and a basic stamp 1

Mike Green
11-09-2006, 07:20 AM
Look up the "Basic Stamp I Application Notes" manual. In section 13, it describes how to connect an EEPROM to a BS1 and use it, complete with full example code.

11-09-2006, 07:45 AM
Here is a link. This used to be part of the old Basic Stamp 1 manual. It's well worth reading if you use the BS1.

www.parallax.com/dl/appnt/stamps/bs1Appnotes.pdf (http://www.parallax.com/dl/appnt/stamps/bs1Appnotes.pdf)

- Rick

Chris Savage
11-09-2006, 08:08 AM

You can also refer to the code for another EEPROM we have on our website. Many EEPROMS have similar addressing schemes which work with more than one model of the same EEPROM type. See the link below for example code.


EDIT: Just realized your title didn't reflect that you were looking for BS1 code...The code I listed is for the BS2.

Chris Savage
Parallax Tech Support

11-09-2006, 08:39 AM
I'll give it a try!!