Using the Parallax 433 MHz RF Receiver with the Propeller.

[lmoliver]

I want to use the Parallax 433 MHz RF Receiver (#27981) with the Propeller Demo Board. http://forums.parallax.com/images/smilies/burger.gif
Somebody has suggested to me to use some standard serial object for communications, but I do not find examples written in Spin.

Also I have tried to emulate then SERIN BS2 command using the “BS2 Functions” object but I’m not able to optimize that code to use only SERIN command (still I do not “dance” well with the SPIN).

Somebody has written something in SPIN to receive data with the RF Receiver?

Thanks

[Martin Hebel]

To use the 433 with the propeller, you should be able to use either the SEROUT/SERIN methods in BS2_Functions or use the FullDuplexSerial library, simply assign the right pins for TX/RX.

-Martin

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Martin Hebel
StampPlot - Graphical Data Acquisition and Control (http://www.stampplot.com/)
AppBee -·2.4GHz Wireless Adapters & transceivers·for the BASIC Stamp & Other controllers (http://www.selmaware.com/appbee)·

[Newzed]

The 433 operates of 5VDC so you need to do something to the output before you feed it to the Prop.

Sid

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Sid Weaver
Don't have VGA?

Newzed@aol.com (mailto:Module?Newzed@aol.com)
·

[Martin Hebel]

I apologize for the imcomplete answer on this, will you be transmitting data from the propeller, or receiving it, or both?
-Martin

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Martin Hebel
StampPlot - Graphical Data Acquisition and Control (http://www.stampplot.com/)
AppBee -·2.4GHz Wireless Adapters & transceivers·for the BASIC Stamp & Other controllers (http://www.selmaware.com/appbee)·

[lmoliver]

Ok, I will try to use again the SEROUT/SERIN methods in BS2_Functions; I will be only receiving data from the propeller.

Thanks