Brian Riley
10-11-2006, 04:14 AM
We are down to 15 PRC Boards. I am looking at a REV 2 design which will be a more flexible board but still retain the heavy SERVO orientation (but only 16 instead of 28). I am also looking at a limited run of a possible Rev 1.03 where I clean up some of the hole and pin alignments, make it usable with the Propeller Plug or the USB2SER, etc.
The bare boards have been reduced to $10/each (qty=1), and $9/each (more than 1). The board and parts kits have another $1 off the reduced board price, and the complete kits with all the Parallax parts reflect these price cuts as well as the Parallax price cut on the Propeller chips.
www.wulfden.org/PRC/ (http://www.wulfden.org/PRC/)
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
cheers ... brian riley, n1bq, underhill center, vermont
See the K107 Serial LCD Controller at
www.wulfden.org/k107/ (http://www.wulfden.org/k107/)
The bare boards have been reduced to $10/each (qty=1), and $9/each (more than 1). The board and parts kits have another $1 off the reduced board price, and the complete kits with all the Parallax parts reflect these price cuts as well as the Parallax price cut on the Propeller chips.
www.wulfden.org/PRC/ (http://www.wulfden.org/PRC/)
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
cheers ... brian riley, n1bq, underhill center, vermont
See the K107 Serial LCD Controller at
www.wulfden.org/k107/ (http://www.wulfden.org/k107/)