PDA

View Full Version : locating PO on PDB



mkeith123
05-17-2006, 10:52 AM
I am doing my first experiment on the proffesional development board. I must connect a wire from the PO on the BS2 to LED 0. I know that pin 5 on the BS2 is PO, but how do I tell which hole no. that corresponds to on the bread board?
The LED 0 is fairly obvious, but not the BS2 pins.

Chris Savage
05-17-2006, 11:37 AM
The I/O pins are already brought out to a header labeled P0-P15...Not the breadboard. See the attachment...You will basically connect a wire between the two points indicated by the arrow.


▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Chris Savage
Parallax Tech Support
csavage@parallax.com (mailto:csavage@parallax.com)


Post Edited (Chris Savage (Parallax)) : 5/17/2006 2:15:11 PM GMT

Jon Williams
05-17-2006, 10:07 PM
You'll find the P0 connection on the right side of header X15 (near the reset button).

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Jon Williams
Applications Engineer, Parallax