PDA

View Full Version : Problem conecting temperature sensor



StarteR2
01-06-2006, 10:36 AM
I have a problem conecting the tempreture sensor. I dont really get it from the instructions since there is no step by step explanation. The diagram shows a sqaure with 8 pins. How do i place the sensor on the board and how do i make conections. Im very knew at this so please go easy on me :) i found the resistors and all. Thanks alot.

Post Edited By Moderator (Chris Savage (Parallax)) : 1/6/2006 3:30:21 AM GMT

Beau Schwabe
01-06-2006, 10:58 AM
StarteR2,

Without knowing what temperature sensor you are using (i.e. a part number) it's hard to determine what exactly it is that you may be having problems with.
Also, a more descriptive subject line might generate a better response.

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Beau Schwabe (mailto:bschwabe@parallax.com)

IC Layout Engineer
Parallax, Inc.

Post Edited (Beau Schwabe (Parallax)) : 1/6/2006 5:00:36 AM GMT

Chris Savage
01-06-2006, 11:29 AM
Hello,



It might also help to have a descriptive subject line explaining what your post is about. I fixed this one for you.

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Chris Savage
Parallax Tech Support
csavage@parallax.com (mailto:csavage@parallax.com)

StarteR2
01-07-2006, 05:47 AM
SHT11 Sensor Module is the sensor, part number #28018.
Thanks

StarteR2
01-07-2006, 10:45 AM
Looking at the digram that came with the Sensor It says that it needs to be conected to Clock and at same time to Vss with 4.7 resistor? Where is the clock? why does it say Vss? What about Data? how do i connect to that? What about the Vdd on square #8, What aboutvthe resistors inside the sensor, do i have to plan them 2? What are these 8 squares? Hw do i insert the detector on the basic stamp pins?


Here are some of my unanswered questions.

Later i tried to do it on my own and here is what i got:


Square four went to a VSS
Square 3 went simply to pin 0 with resistor 4.7
Square one went to Pin 1
Square 8 went to Vdd

I used square cause i dont know how to call that

Post Edited (StarteR2) : 1/7/2006 2:53:11 AM GMT

Bruce Bates
01-07-2006, 04:59 PM
StartR2 -

Here are some applications notes for the SHTxx series of sensors, thanks to Dr. Tracy Allen: http://www.emesystems.com/OL2sht1x.htm

That should get you started.

Regards,

Bruce Bates