View Full Version : Traffic Light Model
jeffrey morris
08-12-2005, 06:19 PM
There is a traffic light model (Volume 1, Column 26) but how can I create the circuit on the Home Work Board?
Tricky Nekro
08-12-2005, 07:12 PM
Yes, yes, yes. It's easy to make but difficult to programm.
If am I right it is writen in PBasic 1.0. You have to convert it!!!
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
-Rule your Destiny-
--Be Good. Be Bad. Be Provas--
dandreae
08-12-2005, 09:13 PM
The circuit uses LEDs with 1k resistors, since the Homework board has built in 220ohm resistors on the·I/O pins·I would change out the 1k resistors for ·470ohm resistors.· Since the LEDs are polarity sensitive you need to connect it as shown in figure 26.2.
Dave
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Dave Andreae
Tech Support
dandreae@parallax.com (mailto:dandreae@parallax.com)
http://www.parallax.com
·
jeffrey morris
08-13-2005, 04:27 AM
Dave, Thanks for helping me create the circuit for the traffic light model. Here's the code:
'{$STAMP BS2}
'{$PBASIC 2.5}
DEBUG "Traffic Light Model"
DO
HIGH 10
PAUSE 500
LOW 4
HIGH 0
PAUSE 1500
LOW 0
HIGH 2
PAUSE 500
LOW 2
HIGH 4
PAUSE 500
LOW 10
HIGH 6
PAUSE 1500
LOW 6
HIGH 8
PAUSE 500
LOW 8
LOOP
dandreae
08-13-2005, 04:33 AM
I take it that everything is working okay?
Dave
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Dave Andreae
Tech Support
dandreae@parallax.com (mailto:dandreae@parallax.com)
http://www.parallax.com
·
jeffrey morris
08-13-2005, 05:33 AM
Everything is working OK. I had to edit the code so that the traffic light works properly.