View Full Version : Parallax Servo Controller (PSC) USB
Oualid
08-12-2005, 05:23 PM
I am wondering if it is possible to use my own application to kommunikate with the Parallax Servo Controller (PSC) USB board.
dandreae
08-12-2005, 09:02 PM
You can use Hyperterminal or any other software that supports the RS-232 protocol.· Basically it requires serial communication.
Dave
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Dave Andreae
Tech Support
dandreae@parallax.com (mailto:dandreae@parallax.com)
http://www.parallax.com
·
Paul Baker
08-12-2005, 09:13 PM
Ron (theronkid) posted a VB.net class to interface with the PSC in this (http://forums.parallax.com/showthread.php?p=546069) thread.
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
·1+1=10
dandreae
08-12-2005, 09:51 PM
Here is a link listed below that will show you information for use in sending binary values·in Hyperterminal.· You'll need to scroll down about half way.
http://www.seetron.com/ht_tip1.htm
Dave
▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Dave Andreae
Tech Support
dandreae@parallax.com (mailto:dandreae@parallax.com)
http://www.parallax.com
·