PDA

View Full Version : basic stamp 2 sx heating up !!



sunil
06-08-2005, 05:06 AM
I find that the Basic Stamp 2SX heats up pretty bad during normal operation, but if functions just fine ... is this normal and is there a way to reduce the heating. I use a 9v battery to power the stamp. I tried using a basic stamp 2 in the circuit and it works fine without heating.

Chris Savage
06-08-2005, 05:09 AM
Hello,

·· Please bear in mind that the SX runs much faster and therefore hotter.· Is it so hot you cannot hold your finger on it for 5 seconds?

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Chris Savage
Parallax Tech Support
csavage@parallax.com (mailto:csavage@parallax.com)

sunil
06-08-2005, 05:13 AM
Hi,
No it is not too hot to touch, it heats up in about 30 seconds and retains that heat, but definitly not too hot to touch. I can keep a finger on it for a long time.. But it just feels strange that it should heat up this much.

dandreae
06-08-2005, 05:25 AM
This is normal with·BS2sx.· I don't recommend using a power supply over 9v when using the BS2sx.



Dave

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Dave Andreae

Tech Support
dandreae@parallax.com (mailto:dandreae@parallax.com)
www.parallax.com (http://www.parallax.com)

·

sunil
06-08-2005, 05:28 AM
thanks a lot !