PDA

View Full Version : cannot stop program



Glen
02-20-2005, 09:44 AM
When I complete any of the "activities" in Robotics with Boe-Bot the led or servo comtinue to blink or rotate. End seems to put the Stamp to sleep mode. An answer from Chris on this forum said to try Finished the GOTO Finish. This has no effect. SAtamp doesnt seem to recognize Finish.
Any help would be appreciated.
Thanks
Glen

Chris Savage
02-20-2005, 10:04 AM
I believe that was something I suggested in another thread...It works...Try:



Finish:
GOTO Finish

Are you using the colong after the label?

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
--==<{Chris}>==--

Chris Savage
02-20-2005, 10:08 AM
Oh, BTW, Finish isn't a keyword, it's a label.· So PBASIC isn't going to "recognize" it as such.



▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
--==<{Chris}>==--

Glen
02-25-2005, 09:40 PM
Chris: Many thanks for your help and patience. It works!! At least I think it seems to. Your magic crystal ball must be working. I overlooked the "colon".

Thanks again

Chris Savage
02-26-2005, 04:21 AM
Glen,

·· No problem.· Another thing you can do is terminate the program with STOP instead of END.· STOP will terminate the program without putting the Stamp into SLEEP mode.· Take Care!



▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
--==<{Chris}>==--

Glen
03-04-2005, 12:47 AM
Hi Chris: Again thanks for your responses. Guess I spoke too soon! I can not get "Finish etc" to work! Will try stop next. What am I doing wrong? Finish seems to have no effect. When the program gets to "loop" it seems to do just that.e.·The LED just·keeps·blinking away·I'm puzzled.

Glen
03-04-2005, 12:49 AM
BTW the servos do NOT continue. Only the LEDS.