PDA

View Full Version : Spinneret Reference Schematic Formats



CassLan
11-27-2010, 03:53 PM
I think the "Open Source" attitude taken by Parallax will do allot for folks who have been hesitant.

I'm just wondering what formats the schematics will be released in?

I know that they are available as graphics now, but I'm looking for a propeller reference schematic for Eagle, and I can't find one.

Thanks,

Rick

CassLan
11-27-2010, 07:32 PM
I'm going to try to create one in eagle, I've started with a simpler one from the manual:

http://forums.parallax.com/showthread.php?t=127462

If it turns out that its ok, I'll proceed to the demo board one, then the spinneret.

Rick

David Carrier
11-29-2010, 10:10 PM
CassLan,
We are in the middle of migrating to a new EDA suite (http://en.wikipedia.org/wiki/Electronic_design_automation), so the Spinneret Web Server PCB was laid out without directly linking to the schematic. Because of this, the schematic only exists as a vector drawing but not as a net-list, so we cannot directly port it to any EDA software, like Eagle. You will need to create it from scratch.

If you make a new one and post it here, send me a PM and I'll double check it against the layout for you.

David Carrier
Parallax Inc.

CassLan
12-01-2010, 01:18 AM
David that would be great thanks!
I will be working on it this weekend when I have some time.

Rick