Native Assembly Code

[Zuddie]

Is there a way to program the Basic Stamp, such as a BS2, to run a snippet of native assembly code for the PIC16F57? I'm guessing not because I think all the BASIC code is in the 24LC16B EPROM chip and that the controller interprets what's in the EPROM but never modifies itself (the controller). Is this true?

[allanlane5]

No. The BS2 PIC16F57 has been programmed to read PBasic tokens out of an attached eeprom and use those tokens to execute pre-programmed assembly code in the PIC. And the PIC was not programmed to allow execution of snippets of assembly stored in the eeprom.

So yes, what you said is true.