PDA

View Full Version : CAM to BS2



Indy_007
03-27-2010, 07:15 AM
I know i am using a old product but does any one have a code or diagram to hook up this camera to the basic stamp i am wanting to use it in some fashion for a project but have no idea where to start, i would like for it to be able to track something any help is helpful thanks

Mike Green
03-27-2010, 07:56 AM
What camera are you talking about? Is it the CMUcam for the BoeBot? If so, there's documentation on the Parallax webstore page.

www.parallax.com/StoreSearchResults/tabid/768/txtSearch/cmucam/List/0/SortField/4/ProductID/29/Default.aspx (http://www.parallax.com/StoreSearchResults/tabid/768/txtSearch/cmucam/List/0/SortField/4/ProductID/29/Default.aspx)

Indy_007
03-27-2010, 07:01 PM
negative, it is this camera i have alot of out puts, it is compatible with sx key which has more horespower, but i thought i might be able to use it someway even if not to it's fullest capacity, i did notice that the camera is the same it is the board that is different, i will try using some of the soruce codes for the older version of the camera, thanks


http://www.ifirobotics.com/camera.shtml

Indy_007
03-27-2010, 07:04 PM
also could you tell me where to hook in, tty or rs232

Mike Green
03-27-2010, 11:53 PM
I think that most of the non-Parallax CMUcams use RS232 signal levels, so follow the examples in the BASIC Stamp Syntax and Reference Manual for connecting RS232 signals to Stamp I/O pins (in the chapters on SERIN and SEROUT).