DIL / DIP Pins, where to source?

[jasonduerr]

Hello good people of the forum!
Can you help me find a source for DIP / DIL pins just like this?

Just the raw pins themselves!

I need extras for a project.

Any leads would be reatly appreciated.



Thanks,
Jason

http://aimtroncorporation.files.wordpress.com/2010/03/bs2-ic.jpg

[hover1]

Best to search for Edge Clip Lead Frame. One supplier is:

·http://batten-allen.com/ba-edgeclip-leadframes/

Hard to find in small lots. Check ebay.

Jim

[jasonduerr]

Thanks, that's pretty much what I was looking for.

[Bean]

Jason,
I have about 50,000 of them. Only trick is they are for 0.050" thick pcb (most is 0.062").
You can get them on 0.062", but it is a struggle.

How many do you require ?

Bean.

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Use BASIC on the Propeller with the speed of assembly language.

PropBASIC thread http://forums.parallax.com/showthread.php?p=867134

March 2010 Nuts and Volts article·http://www.parallax.com/Portals/0/Downloads/docs/cols/nv/prop/col/nvp5.pdf
·

[hover1]

Bean,

I wanted to send him to your site, but the link for CN1002 was not active.

Hope that works out for him.

Jim


Bean said...
Jason,
I have about 50,000 of them. Only trick is they are for 0.050" thick pcb (most is 0.062").
You can get them on 0.062", but it is a struggle.

How many do you require ?

Bean.

[HSPalm]

Just letting you know, I know the thread is old but these pins are also made by TE Connectivity, and are available through the "leadframe" term.