PDA

View Full Version : H-bridge ENABLE pin question.



Jimbo30
03-03-2010, 09:44 PM
I see H-bridge circuits and circuit board kits that use three pins. One for FWD, REV and Enable. Is it always the case that the Enable pin can be used for speed control by sending out PWM commands from the Basic Stamp to the Enable pin of the H-bridge?

Jimbo30
03-03-2010, 09:51 PM
This is the H-bridge I am referring to:
http://www.hobbyengineering.com/H1918.html

Franklin
03-04-2010, 08:19 AM
Since it's made by Solarbotics you should start your search there (I did) www.solarbotics.com/products/k_cmd/resources (http://www.solarbotics.com/products/k_cmd/resources)

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
- Stephen

alexisrq
07-12-2010, 07:13 AM
Did you ever buy this product? Did you have good results?