View Full Version : Need help with 433Mhz RF Transiever!

12-29-2009, 03:43 AM
I've got 2 LINX 433Mhz transievers. One is hooked up to a PPDB and another is hooked up to a ProtoBoard (outfitted with a breadboard). I am using the demo code in the .zip file enclosed and I am using the same·circuit as shown in the·"RF_Transiever" object and I have adjusted the pins to comply with the ones I am using. I place them a foot & 1/2·apart and I get nothing from the serial terminal. I have each programmed with the proper program as in the demo's and still nothing works. Does anyone have experience with these modules?

Computers are microcontrolled.

Robots are microcontrolled.
I am microcontrolled.

But you·can·call me micro.

Want to·experiment with the SX or just put together a cool project?
SX Spinning light display· (http://www.gadgetgangster.com/find-a-project/56?projectnum=200)
My overstock is killing me.
PM me for absolutly FREE 8-pin Mini Din connectors.

Michael O'Brien
12-29-2009, 10:57 AM
·· You will find a lot of info on the use and verification of this code by Beau Schwabe in the following recent post.

"need object for parallax 433 MHz RF Receiver"
·· thank you
·· /michael