PDA

View Full Version : Motor control



Wolfbrother
12-28-2009, 06:48 AM
Hi all,

I'm trying to use the propeller and control one of the 7.2 motors from Parallax for a new project. I ran the motor test program to make sure they work. When I researched the Propeller manual for a PWM command like the basic stamp, it tells me that CTRA and CTRB can be used with a little configuration. Ok. I get that sort of. So I go to the propeller OBX and search PWM and see quite a few options. Turns out, all hardwork is done for me and as long as you are willing to try it out, works just fine.

So in short, thank you all for making this such a nice controller to use. I was worried switching from the Basic Stamp to the Propeller, but so far it's been a dream.

Kye
12-28-2009, 07:19 AM
Go OBEX!

▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔▔
Nyamekye,